The Christine Car Club

Not a member of the CCC? Come on in and register...membership is FREE!


Dedicated To The Restoration And Maintenance Of The 1957-1958 Plymouth
 
HomeCalendarFAQUsergroupsRegisterLog in
Happy Anniversary CCC!
Latest topics
» This Will Take Place
Sun Aug 13, 2017 9:10 pm by furvedere

» Rear seat Frame
Tue Aug 08, 2017 11:09 pm by GG54321

» Frame metal thickness?
Wed Aug 02, 2017 4:10 pm by eva_392

» chrome! where to go?
Wed Aug 02, 2017 12:53 pm by JAG

» Got Peace?
Sun Jul 30, 2017 7:23 pm by goat19642004

» Daily Dose
Fri Jul 28, 2017 10:26 pm by 57belv

» Attention Newcomers To The CCC!
Wed Jul 26, 2017 9:22 pm by 57belv

» Running dual exhausts without a crossover.
Tue Jul 25, 2017 3:50 pm by eva_392

» Wurlitzer Jukebox Model 2510 Project. Any ideas?
Wed Jul 19, 2017 10:42 am by Bloodhound1958

» Aluminium Trim - Reanodise or Paint
Mon Jul 17, 2017 3:43 pm by Red Devil

John Carpenter Shout Out!
Alexandra Paul Shout Out!
Christine Movie Soundtrack
Youtube Filmscore Mix
Share | 
 

 Welding thin steel

View previous topic View next topic Go down 
AuthorMessage
Arnie1964
CCC Member
CCC Member
avatar

"Badass" Poly 318!


Posts : 2514
Points : 3887
Reputation : 0
Join date : 2011-11-08
Age : 70
Location : NC

PostSubject: Welding thin steel   Sun Nov 27, 2011 7:18 am


Back to top Go down
58plym
CCC Member
CCC Member
avatar

Big Block 440 One Bad azz Machine




2009
Posts : 5762
Points : 6577
Reputation : 0
Join date : 2011-11-06
Age : 75
Location : Nampa. Idaho

PostSubject: Re: Welding thin steel   Tue Nov 29, 2011 9:36 am

Good post, I have welded for over 40 years I used to work at A creamery in Caldwell and welded stainless saniitary pipe, I don't do a lot od welding anymore just for myself when something needs fixed. Smile I worked ar a Horse Trailer place also , but that is a different story. Wire welders all you have to do is pull the trigger, I used to have to take something out to the chassie shop when I was workinhg at Fleetwwod homes and if I didn;t watch out I would blow a hole every time if I didn't forget to turn them down, all the knew out there was full blast. Hee! Hee!

_________________

"THE OLDER I GET THE FASTER
Back to top Go down
 

Welding thin steel

View previous topic View next topic Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
The Christine Car Club :: Christine Car Club Tech Section :: Body, Interior & Exterior Trim & Paint:-